Archive for Freesteam For collectors and enthusiasts of all steam engines
 


       Freesteam Forum Index -> The Bickering board!
Mamod Collector

El Salvador

I've just recieved a email from a guy in El Salvador
Asking if I can provide him with the instuctions for the MM1
I think they where printed on the back of the boxes
Does anyone have a scan of the instructions I can send him
I'll of course point him in the direction of the forum.
Spokesmann

Re: El Salvador

Mamod Collector wrote:
I've just recieved a email from a guy in El Salvador
Asking if I can provide him with the instuctions for the MM1
I think they where printed on the back of the boxes
Does anyone have a scan of the instructions I can send him
I'll of course point him in the direction of the forum.


Meths or solid?

I have some SP1 instructions on a box somewhere . . . .
Mamod Collector

Re: El Salvador

Spokesmann wrote:


Meths or solid?

I have some SP1 instructions on a box somewhere . . . .

He didnt say, which ever you have Mike would be ok
If you put the scan up here I'll direct him to this thread Very Happy
avenger

Not got the MM1 but have theses of MM2 any use ?



Spokesmann

Re: El Salvador

Mamod Collector wrote:
Spokesmann wrote:


Meths or solid?

I have some SP1 instructions on a box somewhere . . . .

He didnt say, which ever you have Mike would be ok
If you put the scan up here I'll direct him to this thread Very Happy



Ill try to remember to take a pic tonight . . .
old_timer

Here's a couple of variations to be going along with Very Happy

First the operating instructions to the MM1 with single wick burner



and some general hints for the same model:



Sorry, box has seen better days - the first paragraph reads:

Quote:
1. The asbestos lamp wicks should be kept trimmed and in good order, so that the wicks are level and approximately 1/4" above the top of the burner. If the flame is too small when the lamp has been filled, the wicks are either charred or too low and the engine will run slowly or stop frequently. Keep the wicks clean and replace them when too short.
I know it refers to wicks in the plural, yet the MM1 had a single wick burner, but that's what it says.

Finally, the operating instructions for the vapourising lamp and overflow plug variant



Sorry I don't have any instructions for the new fangled solid fuel and/or sight glass variants.
Mamod Collector

Thx very much for the replies guys
Ill email the link to this thread to the guy in El Salvador.
Spokesmann

USEFUL IMAGES THERE OT, the Camden Street box is quite collectable . . .
Mamod Collector

Just recieved a email from Jose, he is very pleased with the instruction
Email below

My email
Hi Jose
Thx very much for your email, I've made some enquiries about the instructions for the Mamod Minor 1, and they are published on this website.

http://freesteammamod.myfreeforum.org/sutra6434.php#6434

Please feel free to join the Mamod forum, you will be made most welcome
Thx Mike

Jose's return email

Mike:

Thanks a lot for the instructions, they're perfect !

I´m a little bit tied up with work at the moment, but as soon as I have some spare time I'll continue with the Mamod. I think that the fellows with the remote-control airplanes might have some gaskets like the ones I need.

Regards,

José
       Freesteam Forum Index -> The Bickering board!
Page 1 of 1